Home › Vehicle Interior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM24M0E _58 Vehicle Interior _059565 WIPER / WASHER _0291969 WIPER AND WASHER SYSTEM U

WIPER / WASHER  WIPER AND WASHER SYSTEM  TERMINALS OF ECU  


CHECK HEADLIGHT CLEANER CONTROL RELAY


U189827E02
3.448,0.333 3.74,0.521 0.292,0.188 10 false A26

a.

Disconnect the A26 relay connector.


b.

Measure the voltage and resistance of the wire harness side connector.

Symbols (Terminal No.) Wiring Color Terminal Description Condition Specified Condition
IG (A26-3) - Body ground P - Body ground IG signal circuit Ignition switch on (IG) 10 to 14 V
Ignition switch off Below 1 V
E (A26-4) - Body ground W-B - body ground Body ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the A26 relay connector.


d.

Measure the voltage of the connector.

Symbols (Terminal No.) Wiring Color Terminal Description Condition Specified Condition
HDLO (A26-1) - Body ground R - Body ground Headlight LO signal Headlight control switch LO 10 to 14 V
Headlight control switch except LO Below 1 V
H (A26-2) - Body ground R - Body ground Headlight cleaner switch signal Headlight cleaner switch ON,
headlight control switch LO
10 to 14 V
Headlight cleaner switch ON,
headlight control switch except LO
Below 1 V
PB (A26-6) - Body ground L - Body ground Headlight cleaner motor signal Headlight cleaner switch ON,
headlight control switch except LO
10 to 14 V
Headlight cleaner switch ON,
headlight control switch LO
Below 1 V

If the result is not as specified, the headlight cleaner control relay may be malfunctioning.