Home › Vehicle Interior › WIPER / WASHER › REAR WIPER MOTOR › from 2016.05
RM24M0E _58 Vehicle Interior _059565 WIPER / WASHER _0291970 REAR WIPER MOTOR A

WIPER / WASHER  REAR WIPER MOTOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 67939D 2.REMOVE BACK DOOR CENTER GARNISH

Hide 67848 3.REMOVE BACK DOOR SERVICE HOLE COVER LH (for Power Back Door)

Hide 62582H 4.REMOVE REAR WINDOW SIDE GARNISH LH

Hide 62581H 5.REMOVE REAR WINDOW SIDE GARNISH RH

Hide 67750 6.REMOVE BACK DOOR TRIM BOARD ASSEMBLY

Hide 85190R 7.REMOVE REAR WIPER ARM AND BLADE ASSEMBLY

B136377

a.

Widen each end of the cap 5 mm (0.19 in).


b.
B145110

Lift both widened ends of the cap.


c.
B145111

Rotate the cap. Fix the cap in place.


d.
E130185

Remove the nut and arm and blade.


Hide 85143R 8.REMOVE REAR WIPER MOTOR GROMMET

E130186

a.

Remove the rear wiper grommet.


Hide 85110R 9.REMOVE REAR WIPER MOTOR ASSEMBLY

E130187

a.

Disconnect the connector.


b.

Remove the 3 bolts and wiper motor.