Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM24M0E _56 Audio / Visual / Telematics _059566 AUDIO / VIDEO _0291977 AUDIO AND VISUAL SYSTEM C

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  01-DC  Transmission Error  


DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
01-DC* Transmission to component shown by sub-code failed (Detecting this DTC does not always mean actual failure) If same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code

HINT:

*: This code may be stored if the engine is started, idled for 60 seconds and then started again.


NOTICE:
·

Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.

·

The radio receiver is the master unit.

·

Be sure to clear and recheck for DTCs after the inspection is completed to confirm that no DTCs are output.



CAUTION / NOTICE / HINT

NOTICE:

Be sure to read the DESCRIPTION before performing the following procedures.


PROCEDURE

1.CHECK FOR DTC OF OTHER COMPONENTS
a.

Check if the component shown by the sub-code is displayed in the check result of the other components.

i.

Check if "01-DC" is output for the other components.


ii.

If "01-DC" is output for any other components, check if the same physical address is displayed.

Result
Result Proceed to
"01-DC" is output and the same physical address is displayed A
"01-DC" is not output or the same physical address is not displayed B

HINT:

For the list of the components shown by sub-codes, refer to the table in the next step.





A

2.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE

B

4.CLEAR DTC
2.IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE
a.

Enter the diagnostic mode.

E110915E23
1.083,0.781 1.354,0.969 0.271,0.188 10 false *1 1.083,1.323 1.375,1.51 0.292,0.188 10 false *1 1.083,1.854 1.354,2.042 0.271,0.188 10 false *1 1.083,2.354 1.354,2.542 0.271,0.188 10 false *1 1.094,3.24 1.365,3.427 0.271,0.188 10 false *1 0.49,0.698 0.844,0.885 0.354,0.188 10 false *1 4.146,2.594 4.417,2.781 0.271,0.188 10 false *1 4.156,3.042 4.427,3.229 0.271,0.188 10 false *1 4.146,3.635 4.417,3.823 0.271,0.188 10 false *1 4.146,4.156 4.417,4.344 0.271,0.188 10 false *1 4.146,5.01 4.417,5.198 0.271,0.188 10 false *1 4.146,5.896 4.417,6.083 0.271,0.188 10 false *1 3.146,4.479 3.417,4.667 0.271,0.188 10 false *1 4.865,5.896 5.188,6.083 0.323,0.188 10 false *2 4.865,4.99 5.219,5.177 0.354,0.188 10 false *2 4.844,4.156 5.177,4.344 0.333,0.188 10 false *2 4.833,3.635 5.188,3.823 0.354,0.188 10 false *2 4.844,3.052 5.177,3.24 0.333,0.188 10 false *2 4.844,2.594 5.177,2.781 0.333,0.188 10 false *2 6.302,2.469 6.635,2.656 0.333,0.188 10 false *2 1.813,3.24 2.188,3.427 0.375,0.188 10 false *2 1.802,2.354 2.104,2.542 0.302,0.188 10 false *2 1.802,1.854 2.146,2.042 0.344,0.188 10 false *2 1.802,1.323 2.135,1.51 0.333,0.188 10 false *2 1.802,0.781 2.104,0.969 0.302,0.188 10 false *2 2.469,0.708 2.76,0.896 0.292,0.188 10 false *2 3.333,1.896 3.677,2.083 0.344,0.188 10 false *3 2.906,2.323 3.25,2.51 0.344,0.188 10 false *4 0.417,4.979 2.104,5.156 1.688,0.177 10 false *1: SEEK TRACK DOWN 0.427,5.26 1.948,5.438 1.521,0.177 10 false *2: SEEK TRACK UP 0.417,5.531 2.052,5.698 1.635,0.167 10 false *3: PRESET SWITCH "2" 0.427,5.792 2.063,5.958 1.635,0.167 10 false *4: PRESET SWITCH "3" 5.74,3.656 6.063,3.823 0.323,0.167 10 false DTC 3.406,1.26 5.854,1.469 2.448,0.208 10 false Component which has stored this code 2.021,0.198 3.5,0.375 1.479,0.177 10 false Service Check Mode 4.938,0.792 6.823,0.969 1.885,0.177 10 false Detailed Information Mode 3.646,4.479 6.396,4.813 2.75,0.333 10 false Continue to display detailed information of the first code 3.563,5.302 6.656,5.656 3.094,0.354 10 false Continue to display detailed information when more than one DTC is detected 0.458,2.698 2.625,3.073 2.167,0.375 10 false Continue to display when more than two components are installed 0.063,0.042 0.854,0.219 0.792,0.177 10 false Example:


b.

Press the preset switch "2" to change to "Detailed Information Mode".


c.

Identify the component which has stored this code.

Component table
Component Physical address
Television display assembly 1B0
Radio receiver 190

HINT:
·

"440 (Stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.

·

For details of the DTC display, refer to the "DTC CHECK / CLEAR" (see page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).





NEXT

3.CHECK COMPONENT WHICH HAS STORED THIS CODE
3.CHECK COMPONENT WHICH HAS STORED THIS CODE
a.

Select the component which has stored this code.

Component table
Component Proceed to
Television display assembly Television display assembly communication error
Radio receiver Radio receiver communication error



NEXT

END

4.CLEAR DTC
a.

Clear the DTC (see page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).

HINT:

If "01-DC" is output for only one component, this may not indicate a malfunction.




NEXT

5.RECHECK DTC
5.RECHECK DTC
a.

Recheck for the DTC and check if the same trouble occurs again.

OK:

Malfunction disappears.




OK

END

NG

3.CHECK COMPONENT WHICH HAS STORED THIS CODE