Enter the diagnostic mode.
Press the preset switch "2" to change to "Detailed Information Mode".
Identify the component shown by the sub-code.
"190 (radio receiver)" is the component shown by the sub-code in the example shown in the illustration.
For details of the DTC display, refer to the "DTC CHECK / CLEAR" (see page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
Inspect the power source circuit of the component shown by the sub-code.
If the power source circuit is operating normally, proceed to the next step.
| Component | Proceed to |
|---|---|
| Radio receiver (190) | Radio receiver power source circuit |
NEXT
Disconnect the F10 receiver connector.
Measure the resistance of the receiver.
| Tester Connection | Specified Condition |
|---|---|
| F10-9 (TXM+) - F10-10 (TXM-) | 60 to 80 Ω |
OK
NG
Start the check from the circuit that is near the component shown by the sub-code first.
For details of the connectors, refer to the "Terminals of ECU" (see page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>TERMINALS OF ECU).
Referring to the AVC-LAN wiring diagram below, check the AVC-LAN circuit between the television display and the component shown by the sub-code.
Check for an open or short in the AVC-LAN circuit between the television display and the component shown by the sub-code.
There is no open or short circuit.
OK
NG
Replace the component shown by the sub-code with a normal one and check if the same problem occurs again.
Same problem does not occur.
OK
NG