| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| A2-46 | Scratches or dirt is found on disc surface or disc is inserted upside down. | ·
Disc ·
Television display assembly |
After the inspection is completed, clear the DTCs.
Check whether or not the disc is inserted upside down.
Disc is properly inserted.
OK
NG
Check that the disc is not deformed or cracked.
No deformation or cracks on the disc.
OK
NG
If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.
Do not use a conventional record cleaner or antistatic preservative.
NEXT
Clear the DTC (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
NEXT
Recheck for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Replace the disc with a known good one.
Clear the DTC (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
No DTCs are output.
OK
NG