OUTLINE
The Rear Seat Entertainment (RSE) system allows the front and rear seat occupants to select different audio-visual modes at the same time.
The rear seat occupants can control the audio-visual modes with the television switch and volume assembly and listen to the audio using wireless headphones and speakers.
The RSE system is controlled by the television display assembly, and communication between the radio receiver assembly*1, navigation receiver assembly*2 and the television display assembly is established via an Audio Visual Communication-Local Area Network (AVC-LAN).
*1: w/o Navigation System
*2: w/ Navigation System
FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Television display assembly
·
Disc player ·
SD card slot |
·
Displays BD/DVD/SD video images. ·
Receives signals from the television switch and volume assembly. ·
Outputs audio signals to wireless headphones in the form of infrared signals. ·
Receive signals from the external device through the video terminal and displays video images. ·
Displays the audio-visual control screen. ·
Displays the adjustment screen. ·
Displays the diagnosis screen. The diagnosis screen appears when diagnostic mode is started. |
| Navigation receiver assembly*1 | ·
Turns the RSE system on/off. ·
Receives audio signals from the television display assembly and outputs them to the speakers. ·
Enables or disables the function of the television switch and volume assembly for the television display assembly. |
| Radio receiver assembly*2 | ·
Receives audio signals from the television display assembly and outputs them to the speakers. ·
Enables or disables the function of the television switch and volume assembly for the television display assembly. |
| Television switch and volume assembly | Outputs various control signals of the RSE system to the television display assembly in the form of infrared signals. |
| Wireless headphones | ·
Receives audio signals from the television display assembly in the form of infrared signals. ·
Volume adjustment of the wireless headphones can be done by using the volume control on the wireless headphones. |
| Video terminal | This terminal is for connecting an external device's video and audio output terminals. |
*1: w/ Navigation System
*2: w/o Navigation System
DISC PLAYER OUTLINE
A disc player uses a laser pickup to read digital signals recorded on CDs, DVDs or BDs. By converting the digital signals to analog, music and other content can be played.
Do not look directly at the laser pickup because the disc player uses an invisible laser beam. Be sure to operate the player only as instructed.
Do not disassemble any part of the disc player.
Do not apply oil to the disc player.
Do not insert anything but a CD, a DVD or a BD into the disk player.
Usable discs
Precautions for use of discs
Copy-protected CDs cannot be played.
CD-Rs, CD-RWs, DVD-Rs or DVD-RWs may not be played depending on the recording conditions or characteristics of the discs, or due to damage, dirt, or deterioration caused by leaving the discs in the cabin for a long time.
Unfinalized CD-Rs, CD-RWs, DVD-Rs and DVD-RWs cannot be played.
PAL or SECAM color television standard discs cannot be played. (Only NTSC discs can be played.)
DualDiscs that mate DVD recorded material on one side with CD digital audio material on the other cannot be played.
Keep the discs away from dirt. Be careful not to damage the discs or leave fingerprints on them.
Hold discs by the outer edge and center hole with the label side up.
Leaving the disc exposed halfway out of the slot for a long time after pressing the disc eject button may cause deformation of the disc, making the disc unusable.
If discs have adhesive tape, stickers, labels, or any traces of such labels attached, the discs may not be ejected or player malfunctions may result.
Keep the discs away from direct sunlight. (Exposure to direct sunlight may cause deformation of the disc, making the disc unusable.)
Do not use odd-shaped disks because these may cause player malfunctions.
Do not use discs whose recording portion is transparent or translucent because they may not be inserted, ejected, or played normally.
When it is cold or it is raining, if the windows mist up, mist and condensation may form in the player. In such a case, the disc may skip or the disc may stop in the middle of play. Ventilate or dehumidify the cabin for a while before using the player.
The disk may skip if the player experiences strong vibrations when the vehicle is driven on rough road or similar uneven surfaces.
Cleaning
Do not use a lens cleaner because it may cause a malfunction in the pickup portion of the player.
If dirt is on the disc surface, wipe it clean with a soft dry cloth such as an eyeglass cleaner for plastic lenses from the inside to the outside in a radial direction.
Pressing on the disc by hand or rubbing the disc with a hard cloth may scratch the disc surface.
Use of solvents such as record spray, antistatic agents, alcohol, benzine, thinners or a chemical cloth may cause damage to the disc, making the disc unusable.
SD CARD SLOT OUTLINE
The SD card slot can only play JPEG files and AVCHD format video images recorded on SD cards.
DIAGNOSIS FUNCTION
When the diagnostic mode is started, the television display assembly shows the "REAR Check" screen.