ENTER DIAGNOSTIC MODE
Enter diagnostic mode by using the television switch and volume assembly.
Start the engine.
While pressing and holding the "DISPLAY" switch on the television switch and volume assembly, operate the light control switch: Off → Tail → Off → Tail → Off → Tail → Off.
Diagnostic mode starts and the "REAR Check" screen will be displayed.
Enter diagnostic mode by using the display panel on the navigation receiver assembly (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>DTC CHECK / CLEAR).*1
Enter diagnostic mode by using the radio receiver assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).*2
*1: w/ Navigation System
*2: w/o Navigation System
COLOR BAR CHECK
Use the television switch and volume assembly for each inspection.
This mode checks the color display on the television display assembly.
The television display assembly is not a touch panel type. Do not touch the screen.
Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle.
Select "Color Bar Check".
Color Bar Check
Check the display color.
The entire screen turns to the color or stripe selected.
The screen returns to the "Color Bar Check" screen if the television switch and volume assembly is operated again.
REMOTE COMMANDER CHECK
Use the television switch and volume assembly for each inspection.
The remote controller switches are checked in the following procedure.
The television display assembly is not a touch panel type. Do not touch the screen.
Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle.
Select "Remote Commander Check".
Remote Commander Check
Operate each switch and check that the switch name is correctly displayed.
| Display | Content |
|---|---|
| *a: Name of switch being pushed | Name of the pushed switch is displayed |
STARTING SCREEN LANGUAGE
Use the television switch and volume assembly.
The language for the starting screen is selected in this procedure.
The television display assembly is not a touch panel type. Do not touch the screen.
Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle.
Select "Starting Screen Language".
Select the language for starting screen.