Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM
RM24M0E _56 Audio / Visual / Telematics _059566 AUDIO / VIDEO _0291978 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Television Display Power Source Circuit  


DESCRIPTION

This is the power source circuit of the television display assembly.

WIRING DIAGRAM

E153681E11
5.313,2.969 5.646,3.198 0.333,0.229 10 false Q21 5.313,3.156 7.125,3.375 1.813,0.219 10 false Television Display Assembly 5.927,0.573 6.188,0.792 0.26,0.219 10 false +B 5.917,1.354 6.292,1.51 0.375,0.156 10 false ACC 5.917,2.115 6.302,2.313 0.385,0.198 10 false GND 4.51,1.521 5.271,1.688 0.76,0.167 10 false RAD NO. 2 4.51,0.75 5.271,0.917 0.76,0.167 10 false RAD NO. 1 0.604,0.573 1.49,0.76 0.885,0.188 10 false from Battery 0.354,1.344 1.385,1.552 1.031,0.208 10 false from ACC Relay 5.594,1.938 5.771,2.156 0.177,0.219 10 false 17 5.698,1.177 5.813,1.344 0.115,0.167 10 false 2 5.677,0.417 5.854,0.583 0.177,0.167 10 false 1

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY - BATTERY, BODY GROUND)
a.

Disconnect the Q21 television display assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Q21-17 (GND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
Q21-1 (+B) - Body ground Always 11 to 14 V
Q21-2 (ACC) - Body ground Engine switch on (ACC) 11 to 14 V




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR