Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
67492A
2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69278B
3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
74232
4.REMOVE FRONT ARMREST BASE PANEL UPPER LH
67602
5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
86160
6.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
Disconnect the connector.
Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the speaker.
Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
Be careful as the cut rivet will be very hot.
Continue drilling and push out the remaining rivet fragments.
Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.