Home › Audio / Visual / Telematics › AUDIO / VIDEO › STEERING PAD SWITCH › from 2016.05
RM24M0E _56 Audio / Visual / Telematics _059566 AUDIO / VIDEO _0291985 STEERING PAD SWITCH G

AUDIO / VIDEO  STEERING PAD SWITCH  INSPECTION  


PROCEDURE

Hide 1.INSPECT STEERING PAD SWITCH (for 4 Spoke)

a.

Measure the resistance according to the value(s) in the table below.

U189829E02
2.052,1.24 1.677,1.094 false 2.531,1.229 2.917,1.406 false 1.938,1.458 1.542,1.573 false 2.135,0.979 1.729,0.74 false 2.417,0.948 1.854,0.333 false 5.208,1.49 5.333,1.865 false 4.729,0.958 5.021,0.469 false 5.031,0.99 5.406,0.854 false 2.958,1.365 3.24,1.542 0.281,0.177 10 false *d 1.469,0.99 1.74,1.167 0.271,0.177 10 false *e 1.698,0.188 1.969,0.458 0.271,0.271 10 false *b 1.552,0.604 1.76,0.792 0.208,0.188 10 false *c 1.365,1.5 1.552,1.677 0.188,0.177 10 false *f 5.438,0.76 5.917,0.958 0.479,0.198 10 false *g (*A) 5.063,0.281 5.573,0.458 0.51,0.177 10 false *h (*A) 5.344,1.854 5.792,2.042 0.448,0.188 10 false *i (*A) 3.656,0.042 3.865,0.229 0.208,0.188 10 false A 2.552,0.208 2.76,0.396 0.208,0.188 10 false B 0.229,0.115 0.458,0.344 0.229,0.229 10 false *a

Text in Illustration
*A w/ Voice Switch - -
*a Component without harness connected
(Steering Pad Switch)
*b Volume+
*c Volume- *d Seek+
*e Seek- *f MODE
*g On Hook *h Off Hook
*i Voice - -

Standard Resistance:
Tester Connection Condition Specified Condition
A-1 - B-1 Always Below 2.5 Ω
A-10 - A-8 No switch pushed 95 to 105 kΩ
Seek+ switch pushed Below 2.5 Ω
Seek- switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
A-9 - A-8 No switch pushed 95 to 105 kΩ
MODE switch pushed Below 2.5 Ω
On hook switch pushed* 313 to 345 Ω
Off hook switch pushed* 950 to 1050 Ω
Voice switch pushed* 2955 to 3265 Ω


*: w/ Voice Switch


HINT:

If the result is not as specified, replace the steering pad switch.



b.

Check the illumination.

E255323E02
0.354,0.17 0.635,0.386 0.281,0.216 10 *a

Text in Illustration
*a Component without harness connected
(Steering Pad Switch)
- -

i.

Connect a positive (+) lead from the battery to terminal 5 and a negative (-) lead to terminal 8 of the steering pad switch connector.


ii.

Check that the steering pad switch illumination illuminates.

OK:

The steering pad switch illumination illuminates.


HINT:

If the result is not as specified, replace the steering pad switch.




Hide 84250A 2.INSPECT STEERING PAD SWITCH (for 3 Spoke)

a.

Measure the resistance according to the value(s) in the table below.

U189985E02
1.781,2.271 1.208,2 false 1.75,2.552 1.104,2.958 false 2.708,2.219 2.073,2.26 false 2.948,2.958 2.115,2.615 false 6.146,3.021 5.573,2.594 false 6.135,2.229 5.615,2.229 false 5.021,2.5 4.25,3.01 false 5.208,2.219 4.208,2.208 false 5.26,3.573 5.219,2.646 false 5.208,2.396 6.135,1.677 false 5.625,3.313 5.365,2.5 false 1.594,3.542 1.927,2.438 false 0.302,0.208 0.74,0.458 0.438,0.25 10 false *a 2.75,0.385 3.156,0.604 0.406,0.219 10 false A 5.094,1.083 5.5,1.302 0.406,0.219 10 false B 1.021,1.865 1.385,2.115 0.365,0.25 10 false *b 0.896,2.896 1.333,3.146 0.438,0.25 10 false *c 1.458,3.542 1.896,3.792 0.438,0.25 10 false *f 2.979,2.917 3.417,3.167 0.438,0.25 10 false *e 2.729,2.125 3.167,2.375 0.438,0.25 10 false *d 4.083,2.948 4.521,3.198 0.438,0.25 10 false *j 4.01,2.104 4.448,2.354 0.438,0.25 10 false *g 6.156,1.531 6.594,1.781 0.438,0.25 10 false *k 6.156,2.125 6.594,2.375 0.438,0.25 10 false *m 5.219,3.625 5.656,3.875 0.438,0.25 10 false *h 5.583,3.333 6.021,3.583 0.438,0.25 10 false *i 6.146,3.031 6.583,3.281 0.438,0.25 10 false *l

Text in Illustration
*a Component without harness connected
(Steering Pad Switch)
*b Volume+
*c Volume- *d Seek+
*e Seek- *f MODE
*g Up *h Down
*i Right *j Left
*k Enter *l TRIP
*m Back - -

Standard Resistance:
Tester Connection Condition Specified Condition
A-1 - B-1 Always Below 2.5 Ω
A-10 - A-8 No switch pushed 95 to 105 kΩ
Seek+ switch pushed Below 2.5 Ω
Seek- switch pushed 313 to 345 Ω
Volume+ switch pushed 950 to 1050 Ω
Volume- switch pushed 2955 to 3265 Ω
A-9 - A-8 No switch pushed 95 to 105 kΩ
MODE switch pushed Below 2.5 Ω
A-2 - A-8 No switch pushed 95 to 105 kΩ
Enter switch pushed Below 2.5 Ω
TRIP switch pushed 313 to 345 Ω
Back switch pushed 950 to 1050 Ω
A-3 - A-8 No switch pushed 95 to 105 kΩ
Left switch pushed Below 2.5 Ω
Up switch pushed 313 to 345 Ω
Down switch pushed 950 to 1050 Ω
Right switch pushed 2955 to 3265 Ω


HINT:

If the result is not as specified, replace the steering pad switch.



b.

Check the illumination.

E347968E02
0.142,0.306 0.726,0.447 0.583,0.141 10 *a

Text in Illustration
*a Component without harness connected
(Steering Pad Switch)
- -

i.

Connect a positive (+) lead from the battery to terminal 5 and a negative (-) lead to terminal 8 of the steering pad switch connector.


ii.

Check that the steering pad switch illumination illuminates.

OK:

The steering pad switch illumination illuminates.


HINT:

If the result is not as specified, replace the steering pad switch.