The seatback position is initialized at the factory before shipment, so initialization is not normally required.
There is an initialization function for cases when initialization is required.
INITIALIZATION PROCEDURE
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Before starting the following procedure, make sure that the seatback position is not stored in the fold seat control ECU or reclining motor.
If initialization has been completed, initialization cannot be performed. If initialization is required, erase the initialization before starting initialization.
If initialization has not been completed, the 3rd seat indicator on the combination meter will come on regardless of the position of the seatback and the seat legs.
If initialization has been erased or performed, turn the engine switch on (IG) and check the condition of the 3rd seat indicator on the combination meter.
Press and hold the power rear seat switch until the seat is completely folded down.
Continue pressing the power rear seat switch for another 1 second with the seat folded down. Initialization is complete and the buzzer sounds.
INITIALIZATION ERASE PROCEDURE
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
Before starting the following procedure, make sure that the seatback position is stored in the fold seat control ECU and reclining motor (the seatback position is initialized).
Press and hold the stowing / return switch (RETURN).
Within 10 seconds, press the folding switch 5 times while holding the stowing / return switch (RETURN).
Do not release the stowing / return switch (RETURN) until 10 seconds have elapsed.
Pressing the folding switch 6 times or more with the return switch held down disables the initialization erase operation.