Each of the left and right seats has lock switches that detect the lock condition of the seat legs to the floor when the seat is in the original or folded-down state. If any of the lock switches detect an unlock condition, the 3RD SEAT indicator on the combination meter will come on and the folding-down, return, and reclining operations will be disabled.
Remove the fold seat control ECU with the connector still connected.
Measure the voltage of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Z3-38 (LCKF) - Body ground | Any of the lock switches UNLOCK | Below 1 V |
| Z3-38 (LCKF) - Body ground | All lock switches LOCK | 10 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Y3-38 (LCKF) - Body ground | Any of the lock switches UNLOCK | Below 1 V |
| Y3-38 (LCKF) - Body ground | All lock switches LOCK | 10 to 14 V |
NG
OK
Disconnect the Z1*1 or Y1*2 switch connector.
Disconnect the Z3*1 or Y3*2 ECU connector.
Measure the resistance of the wire harness side connectors.
*1: for LH
*2: for RH
| Tester Connection | Specified Condition |
|---|---|
| Z3-38 (LCKF) - Z1-12 (LS+) | Below 1 Ω |
| Z1-1 (E) - Body ground | Below 1 Ω |
| Z3-38 (LCKF) - Body ground | 10 kΩ or higher |
| Tester Connection | Specified Condition |
|---|---|
| Y3-38 (LCKF) - Y1-12 (LS+) | Below 1 Ω |
| Y1-1 (E) - Body ground | Below 1 Ω |
| Y3-38 (LCKF) - Body ground | 10 kΩ or higher |
OK
NG
Since the lock switch cannot be inspected while it is removed from the vehicle, replace the lock switch with a normal one and check that the condition returns to normal.
Same problem does not occur.
OK
NG