Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY(for Tumble Seat Type RH Side)
RM24M0E _58 Vehicle Interior _059567 SEAT _0291997 REAR NO. 2 SEAT ASSEMBLY(for Tumble Seat Type RH Side) A

SEAT  REAR NO. 2 SEAT ASSEMBLY(for Tumble Seat Type RH Side)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR NO. 2 SEAT ASSEMBLY RH

a.

Fully tilt the seatback forward.


b.
B136661

Hold the seat legs in place by inserting screwdrivers to the locations shown in the illustration.

NOTICE:

The striker will not lock if the seat leg is not held in place by inserting the screwdriver.



c.
B140783

Lock the striker on the rear side.

HINT:

Confirm that the seat is firmly locked to the lock striker.



d.

Insert the location pin to the front side and lock the striker.


e.
B140780E01
1.739,1.345 1.895,1.526 0.156,0.181 10 1 0.527,0.924 0.683,1.105 0.156,0.181 10 2

Tighten bolt 1 and then bolt 2 on the front side.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


f.
B140781E01
1.934,1.213 2.090,1.394 0.156,0.181 10 1 0.731,0.867 0.887,1.048 0.156,0.181 10 2

Remove the screwdriver.


g.

Tighten bolt 1 and then bolt 2 on the rear side.

Torque:
39 N*m (398 kgf*cm, 29 ft.*lbf)


Hide 72137E 2.INSTALL NO. 1 SEAT TRACK COVER

a.
B135823

Attach the 4 claws to install the 2 covers.