Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
71910A
2.REMOVE FRONT SEAT HEADREST ASSEMBLY
3.REMOVE FRONT SEAT ASSEMBLY
Lift up the seat track adjusting handle and move the seat to the foremost position.
Lift up the vertical adjusting handle and move the seat to the uppermost position.
Using a screwdriver, detach the 4 claws on the rear side of the front seat leg cover. Then open the 2 covers.
Tape the screwdriver tip before use.
Remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Using a screwdriver, detach the 4 claws on the front side of the front seat leg cover. Then open the 2 covers.
Tape the screwdriver tip before use.
Remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Disconnect the connector under the seat.
Remove the seat.
Be careful not to damage the vehicle body.