Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat)
RM24M0E _58 Vehicle Interior _059567 SEAT _0291999 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 71910A 1.REMOVE FRONT SEAT HEADREST ASSEMBLY

Hide 2.REMOVE FRONT SEAT ASSEMBLY

a.

Operate the power seat switch knob and move the seat to the foremost position.


b.

Operate the slide and vertical power seat switch knob and move the seat to the uppermost position.


c.
B136533E01
0.123,2.677 0.511,2.868 0.387,0.191 10 Open 1.686,3.494 2.073,3.685 0.387,0.191 10 Open

Using a screwdriver, detach the 4 claws on the rear side of the front seat leg cover. Then open the 2 covers.

HINT:

Tape the screwdriver tip before use.



d.
B141472

Remove the 2 bolts on the rear side of the seat.


e.

Operate the power seat switch knob and move the seat to the rearmost position.


f.
B141898

Using a screwdriver, detach the 4 claws on the front side of the front seat leg cover. Then open the 2 covers.

HINT:

Tape the screwdriver tip before use.



g.
B141899

Remove the 2 bolts on the front side of the seat.


h.

Operate the power seat switch knob and move the seat to the center position. Then, operate the power seat switch knob and move the seatback to the upright position.


i.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



j.

Disconnect the connectors under the seat. Then remove the seat.

NOTICE:

Be careful not to damage the vehicle body.