Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM
RM24M0E _58 Vehicle Interior _059567 SEAT _0292006 FRONT POWER SEAT CONTROL SYSTEM G

SEAT  FRONT POWER SEAT CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CHECK POWER SEAT FUNCTION

B142030E02
2.635,0.823 2.635,1.833 2.635,1.833 2.469,2.104 false 0.646,1.813 0.646,2.208 0.646,2.208 1.781,2.781 false 0.552,3.344 0.552,2.896 0.552,2.896 1.167,2.896 false 2.365,3.344 2.938,3.344 2.938,3.344 2.938,3.594 false 1.948,0.563 3.208,0.76 1.26,0.198 10 false Reclining Function 0.25,1.604 1.25,1.854 1,0.25 10 false Lifter Function 2.333,3.635 3.354,3.833 1.021,0.198 10 false Sliding Function 0.073,3.365 1.521,3.552 1.448,0.188 10 false Front Vertical Function

a.

Check the basic functions.

i.

Operate the power seat switches and check to make sure each seat function works:

·

Sliding

·

Front vertical

·

Lifter

·

Reclining




Hide 71120B 2.CHECK FRONT SEAT WITH ADJUSTER FRAME (SLIDING, FRONT VERTICAL, LIFTER AND RECLINING FUNCTIONS)

a.

Check the PTC operation inside the power seat motor.

HINT:

The PTC thermistor's resistance increases when the power seat switch is held down even after the power seat has been moved to the maximum in one direction. If the resistance increases beyond a specified level, current is cut to prevent a short circuit.


NOTICE:
·

The inspection should be performed with the seat installed in the vehicle.

·

Perform the 4 steps below for the full range of motion for each power seat function.



i.

Choose a power seat function. Operate the power seat switch and move the seat as much as possible in one direction. Keep the seat in that position for approximately 60 seconds.


ii.

Operate the power seat switch again and continue to try to move the seat in the same direction as in the previous step. Measure the amount of time elapsed before current is automatically cut (the sound of the motor has stopped).

Standard:

4 to 90 seconds



iii.

After current has been cut, release the power seat switch and wait for approximately 60 seconds.


iv.

Operate the same power seat switch and move the seat in the opposite direction. Check that the motor operates.