Home › Vehicle Interior › SEAT › REAR NO. 1 SEAT ASSEMBLY(for Captain Seat Type)
RM24M0E _58 Vehicle Interior _059567 SEAT _0292007 REAR NO. 1 SEAT ASSEMBLY(for Captain Seat Type) A

SEAT  REAR NO. 1 SEAT ASSEMBLY(for Captain Seat Type)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 72180 1.INSTALL REAR SEAT TRACK ASSEMBLY INNER LH

a.

Install the rear seat track inner with the 4 nuts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)


b.

Install the 2 seat track lower rail protectors.


c.
B143829

Install the 2 floor carpet mouldings and, using a screwdriver, rotate the clips clockwise to engage them.


Hide 72170 2.INSTALL REAR SEAT TRACK ASSEMBLY OUTER LH

a.

Install the rear seat track outer with the 4 nuts.

Torque:
72 N*m (734 kgf*cm, 53 ft.*lbf)


b.

Install the 2 seat track lower rail protectors.


c.
B143829

Install the 2 floor carpet mouldings and, using a screwdriver, rotate the clips clockwise to engage them.


Hide 3.INSTALL REAR NO. 1 SEAT ASSEMBLY LH

a.

Place the seat in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

Lift up the seat track adjusting handle and move the seat to the foremost position.


c.
B143791E01
1.479,1.751 1.581,1.898 0.103,0.148 10 1 0.089,1.006 0.190,1.163 0.101,0.157 10 2

Install the 2 bolts.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)

HINT:

Tighten the bolts in the order indicated in the illustration.



d.
B145901

Attach the 4 claws on the rear side of the seat leg covers. Then close the 2 covers.


e.

Lift up the seat track adjusting handle and move the seat to the rearmost position.


f.
B143793E03
1.625,1.302 1.781,1.479 0.156,0.177 10 false A 0.344,0.823 0.5,1 0.156,0.177 10 false B

Pull the side sliding handle and slide the seat toward the outer position.


g.

Install the bolt B.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


h.

Pull the side sliding handle and slide the seat toward the inner position.


i.

Install the bolt A.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


j.
B145902

Attach the 4 claws on the front side of the seat leg covers. Then close the 2 covers.


Hide 71940A 4.INSTALL REAR SEAT HEADREST ASSEMBLY