Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
71940A
1.REMOVE REAR SEAT HEADREST ASSEMBLY
2.REMOVE REAR NO. 1 SEAT ASSEMBLY LH
Lift up the seat track adjusting handle and move the seat to the foremost position.
Using a screwdriver, detach the 4 claws on the rear side of the front seat leg cover. Then open the 2 covers.
Tape the screwdriver tip before use.
Remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Using a screwdriver, detach the 4 claws on the front side of the front seat leg covers.
Tape the screwdriver tip before use.
Pull the side sliding handle and slide the seat toward the inner position.
Remove bolt A.
Pull the side sliding handle and slide the seat toward the outer position.
Remove bolt B.
Remove the seat.
Be careful not to damage the vehicle body.
72170
3.REMOVE REAR SEAT TRACK ASSEMBLY OUTER LH
Using a screwdriver, rotate the clips counterclockwise to disengage them, and remove the 2 floor carpet mouldings.
Remove the 2 seat track lower rail protectors.
Remove the 4 nuts and rear seat track assembly outer.
72180
4.REMOVE REAR SEAT TRACK ASSEMBLY INNER LH
Using a screwdriver, rotate the clips counterclockwise to disengage them, and remove the 2 floor carpet mouldings.
Remove the 2 seat track lower rail protectors.
Remove the 4 nuts and rear seat track assembly inner.