Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM
RM24M0E _58 Vehicle Interior _059568 DOOR LOCK _0292010 WIRELESS DOOR LOCK CONTROL SYSTEM D

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


a.

Wireless door lock control system data can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform repairs.



CHECK DLC3


H103023E08
1.615,0.906 1.177,0.552 true 2.604,1.823 2.313,1.49 true 2.135,0.927 2.219,0.531 true 1.75,0.917 1.625,0.563 true 1.031,0.344 1.625,0.698 0.594,0.354 10 false CG 2.51,1.865 3.052,2.135 0.542,0.271 10 false BAT 1.51,0.344 2.104,0.698 0.594,0.354 10 false SG 2.135,0.354 2.729,0.708 0.594,0.354 10 false SIL

B135940E01
0.425,2.845 1.557,3.021 1.132,0.177 10 Intelligent Tester 0.6,2.589 0.6,2.832 false 1.48,2.058 1.864,2.214 0.385,0.156 10 DLC3 1.717,2.051 1.841,1.732 false

HINT:

The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.

Symbols (Terminal No.) Terminal Description Condition Specified Condition
SIL (7) - SG (5) Bus "+" line During transmission Pulse generation
CG (4) - Body ground Chassis ground Always Below 1 Ω
SG (5) - Body ground Signal ground Always Below 1 Ω
BAT (16) - Body ground Battery positive Always 10 to 14 V

If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.


HINT:

Connect the cable of the intelligent tester to the DLC3, turn the ignition switch on (IG) and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem either with the vehicle or with the tester.

·

If communication is normal when the tester is connected to another vehicle, inspect the DLC3 on the original vehicle.

·

If communication is still not possible when the tester is connected to another vehicle, the problem is probably in the tester itself. Consult the Service Department listed in the tester's instruction manual.