READ DATA LIST
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body or Entry&Start / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door is open
OFF: Driver side door is closed |
- |
| D-Door Lock Pos SW | Driver side door lock position switch signal / ON or OFF | ON: Driver side door is unlocked
OFF: Driver side door is locked |
- |
| Door Key SW-Lock | Door key linked lock switch signal / ON or OFF | ON: Driver side door key cylinder is turned to lock position
OFF: Driver side door key cylinder is turned to unlock position |
- |
| Door Key SW-Unlock | Door key linked unlock switch signal / ON or OFF | ON: Driver side door key cylinder is turned to unlock position
OFF: Driver side door key cylinder is turned to lock position |
- |
| P Door Courtesy SW | Passenger side door courtesy light switch signal / ON or OFF | ON: Passenger side door is open
OFF: Passenger side door is closed |
- |
| P-Door Lock Pos SW | Passenger side door lock position switch signal / ON or OFF | ON: Passenger side door is unlocked
OFF: Passenger side door is locked |
- |
| RR Door Courtesy SW | Slide door RH courtesy light switch signal / ON or OFF | ON: Slide door RH is open
OFF: Slide door RH is closed |
- |
| RR-Door Lock Pos SW | Slide door RH lock position switch signal / ON or OFF | ON: Slide door RH is unlocked
OFF: Slide door RH is locked |
- |
| RL Door Courtesy SW | Slide door LH courtesy light switch signal / ON or OFF | ON: Slide door LH is open
OFF: Slide door LH is closed |
- |
| RL-Door Lock Pos SW | Slide door LH lock position switch signal / ON or OFF | ON: Slide door LH is unlocked
OFF: Slide door LH is locked |
- |
| Back Door Courtesy SW | Back door courtesy light switch signal / ON or OFF | ON: Back door is open
OFF: Back door is closed |
- |
PERFORM ACTIVE TEST
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range |
|---|---|---|
| Door Lock | Door lock motor OFF / Unlock / Lock | - |
| Hazard*1 | Turn signal flasher relay ON / OFF | - |
| Trunk and Back-Door Open | Back door lock motor ON / OFF | - |
*: for LHD
| Tester Display | Test Part | Control Range |
|---|---|---|
| Wireless Buzzer | Operate wireless door lock buzzer ON / OFF | - |