CHECK DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester ON.
Select the following menu items: Body / Body ECU / DTC.
Check for DTCs and then write them down.
Refer to the intelligent tester operator's manual for further details.
Confirm the details of the DTCs.
CLEAR DTC (Using Intelligent Tester)
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester ON.
Select the following menu items: Body / Body ECU / DTC / Clear.
Refer to the intelligent tester operator's manual for further details.
Erase DTCs by pressing the YES button on the tester.
Refer to the intelligent tester operator's manual for further details.
CLEAR DTC (Without Using Intelligent Tester)
Remove the ECU-B fuse from the engine room No. 2 relay block for more than 60 seconds, or disconnect the cable from the negative (-) battery terminal for more than 60 seconds. If disconnecting the cable from the negative (-) battery terminal, perform the "INITIALIZATION" procedure.