Home › Vehicle Interior › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM
RM24M0E _58 Vehicle Interior _059568 DOOR LOCK _0292011 POWER DOOR LOCK CONTROL SYSTEM J

DOOR LOCK  POWER DOOR LOCK CONTROL SYSTEM  Front Passenger Side Door Courtesy Switch Circuit  


DESCRIPTION

The front passenger side door courtesy light switch turns on when the driver side door is opened and turns off when the door is closed. The main body ECU applies voltage to the front passenger side door courtesy light switch. Front passenger side door open / close state signals are input to the main body ECU.

WIRING DIAGRAM

B138811E12
1.469,1.771 3.563,2.125 2.094,0.354 10 false Front Door Courtesy Light Switch (for Front Passenger Side) 4.875,2.198 5.896,2.396 1.021,0.198 10 false Main Body ECU 0.104,2.125 0.865,2.302 0.76,0.177 10 false *1: for LHD 0.104,2.417 0.865,2.615 0.76,0.198 10 false *2: for RHD 4.875,2.042 5.219,2.24 0.344,0.198 10 false G58 4.646,1.021 4.865,1.219 0.219,0.198 10 false 21 3.354,1.021 3.521,1.219 0.167,0.198 10 false 1 1.469,1.604 2.313,1.802 0.844,0.198 10 false N1*1, M5*2 4.938,1.177 5.375,1.344 0.438,0.167 10 false PCTY

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (FRONT PASSENGER SIDE DOOR COURTESY LIGHT SWITCH)
a.

Use the Data List to check if the door courtesy light switch is functioning properly.

Main body ECU
Item Measurement Item / Display (Range) Normal Condition Diagnostic Note
P Door Courtesy SW Front passenger side door courtesy light switch signal / ON or OFF ON: Front passenger side door is open
OFF: Front passenger side door is closed
-

OK:

When the switch is operating, the intelligent tester should display as shown in the table.




NG

2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH (for Front Passenger Side)

OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2.INSPECT FRONT DOOR COURTESY LIGHT SWITCH (for Front Passenger Side)
a.
E114552E09
0.927,1.188 1.688,1.833 false 1.458,0.135 2.573,0.313 1.115,0.177 10 false Not Pushed (ON) 1.521,0.563 2.469,0.75 0.948,0.188 10 false Pushed (OFF) 1.74,1.771 2.625,1.938 0.885,0.167 10 false Body Ground

Remove the door courtesy light switch.


b.

Measure the resistance of the door courtesy switch connector.

Standard resistance:
Tester Connection Condition Specified Condition
1 - Body ground Pushed (OFF) 10 kΩ or higher
1 - Body ground Not pushed (ON) Below 1 Ω




OK

3.CHECK WIRE HARNESS (SWITCH - ECU AND BODY GROUND)

NG

REPLACE FRONT DOOR COURTESY LIGHT SWITCH (for Front Passenger Side)

3.CHECK WIRE HARNESS (SWITCH - ECU AND BODY GROUND)
a.
U188774E02
1.146,3.948 1.417,4.396 false 0.115,0.083 1.427,0.26 1.313,0.177 10 false Wire Harness Side: 0.979,0.5 2.76,0.729 1.781,0.229 10 false Door Courtesy Light Switch 0.708,1.677 0.958,1.823 0.25,0.146 10 false M5 0.719,1.281 0.948,1.448 0.229,0.167 10 false N1 1.073,1.271 1.302,1.458 0.229,0.188 10 false *1 1.063,1.677 1.25,1.823 0.188,0.146 10 false *2 1.24,2.667 2.292,2.854 1.052,0.188 10 false Main Body ECU 0.417,3.469 0.719,3.656 0.302,0.188 10 false G58 1.354,4.417 1.75,4.573 0.396,0.156 10 false PCTY 0.083,4.073 0.844,4.24 0.76,0.167 10 false *1: for LHD 0.104,4.333 0.865,4.51 0.76,0.177 10 false *2: for RHD

for LHD:

i.

Disconnect the N1 switch connector.


ii.

Disconnect the G58 ECU connector.


iii.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
N1-1 - G58-21 (PCTY) Below 1 Ω
N1-1 - Body ground 10 kΩ or higher




b.

for RHD:

i.

Disconnect the M5 switch connector.


ii.

Disconnect the G58 ECU connector.


iii.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
M5-1 - G58-21 (PCTY) Below 1 Ω
M5-1 - Body ground 10 kΩ or higher





OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR