69040A
1.INSPECT FRONT DOOR LOCK ASSEMBLY (for Driver Side)
for LHD:
Apply battery voltage to the motor terminals and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL) |
Lock |
| Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L) |
Unlock |
If the result is not as specified, replace the door lock assembly.
Measure the resistance of the unlock detection switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (LSSR) - 7 (E) | Lock | 10 kΩ or higher |
| 8 (LSSR) - 7 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the door lock assembly.
for RHD:
Apply battery voltage to the motor terminals and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL) |
Lock |
| Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L) |
Unlock |
If the result is not as specified, replace the door lock assembly.
Measure the resistance of the unlock detection switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (LSSR) - 8 (E) | Lock | 10 kΩ or higher |
| 7 (LSSR) - 8 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the door lock assembly.
69030A
2.INSPECT FRONT DOOR LOCK ASSEMBLY (for Front Passenger Side)
for LHD:
Apply battery voltage to the motor terminals and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL) |
Lock |
| Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L) |
Unlock |
If the result is not as specified, replace the door lock assembly.
Measure the resistance of the door unlock detection switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (LSSR) - 8 (E) | Lock | 10 kΩ or higher |
| 7 (LSSR) - 8 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the door lock assembly.
for RHD:
Apply battery voltage to the motor terminals and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 4 (L)
Battery negative (-) → 1 (UL) |
Lock |
| Battery positive (+) → 1 (UL)
Battery negative (-) → 4 (L) |
Unlock |
If the result is not as specified, replace the door lock assembly.
Measure the resistance of the unlock detection switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (LSSR) - 7 (E) | Lock | 10 kΩ or higher |
| 8 (LSSR) - 7 (E) | Unlock | Below 1 Ω |
If the result is not as specified, replace the door lock assembly.