Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM24M0E _58 Vehicle Interior _059568 DOOR LOCK _0292014 REAR DOOR LOCK G

DOOR LOCK  REAR DOOR LOCK  INSPECTION  


PROCEDURE

Hide 69140 1.INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY LH

a.
B256274E10
2.635,0.36 3.077,0.542 0.442,0.181 10 Unlock 0.431,0.399 0.742,0.580 0.310,0.181 10 Lock 1.474,0.941 1.185,0.503 1.185,0.503 0.829,0.503 false 1.953,1.053 2.286,0.443 2.286,0.443 2.611,0.443 false 0.931,3.492 1.087,3.673 0.156,0.181 10 E 1.34,3.493 1.534,3.674 0.195,0.181 10 UL 1.933,3.493 2.089,3.674 0.156,0.181 10 L 2.206,3.492 2.598,3.660 0.392,0.167 10 LSSR 1.444,4.217 1.043,3.673 false 1.639,4.204 1.454,3.669 false 2.023,4.217 2.424,3.673 false 1.827,4.204 2.012,3.67 false

Apply battery voltage to the motor terminals and check the operation of the door lock motor.

OK:
Measurement Condition Result
Battery positive (+) → 2 (L)
Battery negative (-) → 3 (UL)
Locks
Battery positive (+) → 3 (UL)
Battery negative (-) → 2 (L)
Unlocks


If the result is not as specified, replace the rear door lock actuator assembly LH.



b.

Measure the resistance of the door unlock detection switch.

Standard resistance:
Tester Connection Condition Specified Condition
1 (LSSR) - 4 (E) Locked 10 kΩ or higher
1 (LSSR) - 4 (E) Unlocked Below 1 Ω


If the result is not as specified, replace the rear door lock actuator assembly LH.



Hide 69130 2.INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY RH

a.
B256272E07
0.285,0.427 0.727,0.609 0.442,0.181 10 Unlock 2.784,0.208 3.094,0.390 0.310,0.181 10 Lock 1.544,1.011 1.227,0.52 1.227,0.52 0.838,0.52 false 2.003,0.903 2.381,0.301 2.381,0.301 2.75,0.301 false 0.94,3.452 1.096,3.633 0.156,0.181 10 E 2.215,3.452 2.607,3.619 0.392,0.167 10 LSSR 1.452,4.177 1.051,3.632 false 2.032,4.177 2.433,3.633 false 1.818,4.169 1.997,3.625 false 1.949,3.453 2.075,3.620 0.126,0.167 10 L 1.639,4.158 1.46,3.614 false 1.342,3.449 1.560,3.617 0.218,0.167 10 UL

Apply battery voltage to the motor terminals and check the operation of the door lock motor.

OK:
Measurement Condition Result
Battery positive (+) → 2 (L)
Battery negative (-) → 3 (UL)
Locks
Battery positive (+) → 3 (UL)
Battery negative (-) → 2 (L)
Unlocks


If the result is not as specified, replace the rear door lock actuator assembly RH.



b.

Measure the resistance of the door unlock detection switch.

Standard resistance:
Tester Connection Condition Specified Condition
1 (LSSR) - 4 (E) Locked 10 kΩ or higher
1 (LSSR) - 4 (E) Unlocked Below 1 Ω


If the result is not as specified, replace the rear door lock actuator assembly RH.