Home › Vehicle Interior › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292018 BACK DOOR CLOSER SYSTEM U

ENGINE HOOD / DOOR  BACK DOOR CLOSER SYSTEM  TERMINALS OF ECU  


CHECK POWER BACK DOOR UNIT (POWER BACK DOOR ECU)


U190037E02
3.448,0.677 3.74,0.823 0.292,0.146 10 false M24

a.

Disconnect the M24 ECU connector.


b.

Measure the voltage and resistance of the wire harness side connector.

Symbols (Terminal No.) Wiring Color Terminal Description Condition Specified Condition
B (M24-12) - Body ground B - Body ground Battery power supply Always 10 to 14 V
ECUB (M24-10) - Body ground R - Body ground ECUB power supply Always 10 to 14 V
IG (M24-8) - Body ground R - Body ground IG power supply Ignition switch on (IG) 10 to 14 V
IG (M24-8) - Body ground R - Body ground IG power supply Ignition switch off Below 1 V
GND (M24-11) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction in the wire harness.


c.

Reconnect the M24 ECU connector.


d.

Measure the voltage of the connector.

Symbols (Terminal No.) Wiring Color Terminal Description Condition Specified Condition
DC+ (M24-2) - DC- (M24-1) B - R Back door lock motor circuit Back door lock motor is operating 10 to 14 V
DC+ (M24-2) - DC- (M24-1) B - R Back door lock motor circuit Back door lock motor is not operating Below 1 V
FUL (M24-20) - Body ground V - Body ground Back door courtesy switch circuit Back door is closed 10 to 14 V
FUL (M24-20) - Body ground V - Body ground Back door courtesy switch circuit Back door is open Below 1 V
HAF (M24-22) - Body ground GR - Body ground Back door lock half-latch switch signal circuit Back door opened → Back door closer motor is operating → Back door is closed Below 1 V → 10 to 14 V → Below 1 V
POS (M24-24) - Body ground P - Body ground Back door lock position switch signal circuit Back door is opened → Back door closer motor is operating → Back door is closed Below 1 V → 10 to 14 V → Below 1 V

If the result is not as specified, the ECU may have a malfunction.