Home › Vehicle Interior › ENGINE HOOD / DOOR › BACK DOOR CLOSER SYSTEM
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292018 BACK DOOR CLOSER SYSTEM C

ENGINE HOOD / DOOR  BACK DOOR CLOSER SYSTEM  B2251  Back Door Closer Switch Malfunction  


DESCRIPTION

The power back door unit (power back door ECU) inputs signals from the full-latch switch, selector switch and back door courtesy light switch, which are built into the back door lock. Based on these switch signals, the latch position of the back door lock is determined.

DTC No. DTC Detection Condition Trouble Area
B2251 While back door closer is operating, malfunction is detected in position information from each switch within specified amount of time
·

Back door lock

·

Wire harness

·

Power back door unit (Power back door ECU)



WIRING DIAGRAM

B144402E28
3.042,0.583 3.365,0.729 0.323,0.146 10 false CTY 3.375,0.573 3.698,0.719 0.323,0.146 10 false 3 5.635,0.448 5.917,0.635 0.281,0.188 10 false FUL 1.802,1.042 4.01,1.375 2.208,0.333 10 false Back Door Lock (Back Door Courtesy Light Switch) 2.448,0.583 2.583,0.771 0.135,0.188 10 false E 2.26,0.583 2.396,0.771 0.135,0.188 10 false 4 5.354,1.313 5.656,1.49 0.302,0.177 10 false M24 5.375,1.5 6.927,1.833 1.552,0.333 10 false Power Back Door Unit (Power Back Door ECU) 5.344,0.583 5.583,0.74 0.24,0.156 10 false 20 1.802,0.833 2.104,0.979 0.302,0.146 10 false S12

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (BACK DOOR COURTESY LIGHT SWITCH)
a.

Check the Data List for proper functioning of the back door courtesy light switch.

Power back door unit (Power back door ECU):
Item Measurement Item / Display (Range) Normal Condition Diagnostic Note
Courtesy SW Back door courtesy light switch signal / ON or OFF ON: Back door is open
OFF: Back door is closed
-


OK:

The display is as specified in the normal condition.




NG

2.INSPECT BACK DOOR LOCK (BACK DOOR LOCK COURTESY LIGHT SWITCH)

OK

REPLACE POWER BACK DOOR UNIT (POWER BACK DOOR ECU)

2.INSPECT BACK DOOR LOCK (BACK DOOR LOCK COURTESY LIGHT SWITCH)
B143899E25
3.083,2.51 3.75,3.583 3.75,3.583 3.802,3.583 false 5.365,1.927 5.865,2.313 false 4.656,2.25 5.188,1.938 false 4.427,3.958 5.125,4.115 0.698,0.156 10 false Over-latch 4.323,4.281 4.938,4.427 0.615,0.146 10 false Full-latch 4.115,5.229 4.729,5.375 0.615,0.146 10 false Half-latch 3.719,5.854 4.448,6.031 0.729,0.177 10 false Open-latch 3.198,1.771 3.604,2.042 0.406,0.271 10 true Close 2.198,1.729 2.708,1.99 0.51,0.26 10 true Release 3.823,3.531 4.531,3.688 0.708,0.156 10 false Drive Gear 4.542,2.188 4.677,2.344 0.135,0.156 10 false E 5.896,2.271 6.198,2.417 0.302,0.146 10 false CTY

a.

Remove the back door lock.


b.

Measure the resistance of the switch.

Standard resistance:
Tester Connection Door lock latch Position Specified Condition
3 (CTY) - 4 (E) Open-latch Below 1 Ω
3 (CTY) - 4 (E) Half-latch Below 1 Ω
3 (CTY) - 4 (E) Full-latch 10 kΩ or higher
3 (CTY) - 4 (E) Over-latch 10 kΩ or higher




OK

3.CHECK WIRE HARNESS (BACK DOOR LOCK - POWER BACK DOOR UNIT AND BODY GROUND)

NG

REPLACE BACK DOOR LOCK

3.CHECK WIRE HARNESS (BACK DOOR LOCK - POWER BACK DOOR UNIT AND BODY GROUND)
U188668E02
1.76,4.365 1.927,4.104 false 1.854,1.917 2.229,2 false 1.604,1.917 1.198,1.979 false 0.052,0.021 1.542,0.167 1.49,0.146 10 false Wire Harness Side: 1.125,0.781 2.135,0.938 1.01,0.156 10 false Back Door Lock 0.24,1.688 0.552,1.844 0.313,0.156 10 false S12 0.823,2.51 2.396,2.854 1.573,0.344 10 false Power Back Door Unit (Power Back Door ECU) 0.167,3.74 0.479,3.885 0.313,0.146 10 false M24 2.292,1.927 2.76,2.073 0.469,0.146 10 false E 0.802,1.896 1.271,2.042 0.469,0.146 10 false CTY 1.563,4.406 1.906,4.552 0.344,0.146 10 false FUL

a.

Disconnect the S12 door lock connector.


b.

Disconnect the M24 ECU connector.


c.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
S12-3 (CTY) - M24-20 (FUL) Below 1 Ω
S12-4 (E) - Body ground Below 1 Ω
S12-3 (CTY) - Body ground 10 kΩ or higher




OK

REPLACE POWER BACK DOOR UNIT (POWER BACK DOOR ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR