CHECK DTC
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the intelligent tester ON.
Select the following menu items: Body / Body ECU / DTC.
Check DTCs and then write them down.
If you need help when using the intelligent tester, refer to the instruction manual.
Confirm the details of the DTCs.
CLEAR DTC (Using Intelligent Tester)
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) (do not start the engine) and turn the intelligent tester ON.
Select the following menu items: Body / Body ECU / DTC / Clear.
Refer to the intelligent tester operator's manual for further details.
Erase DTCs by pressing the YES button on the tester.
If you need help when using the intelligent tester, refer to the instruction manual.
CLEAR DTC (Without Using Intelligent Tester)
Remove the ECU-B fuse from the engine room No. 2 relay block for more than 60 seconds, or disconnect the cable from the negative (-) battery terminal for more than 60 seconds. If disconnecting the cable from the negative (-) battery terminal, perform the "INITIALIZE" procedure.