READ DATA LIST
Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Read the Data List on the tester screen.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnosis Note |
|---|---|---|---|
| Pole Switch | Slide door lock pawl position switch signal / ON or OFF | ON: Slide door open to partially closed door or partially closed door to slide door closed
OFF: Slide door fully open, closed and partially closed |
- |
| Half Switch | Slide door lock half-latch switch signal / ON or OFF | ON: Slide door open to partially closed
OFF: Partially closed to fully closed |
- |
| Full Switch | Slide door lock full-latch switch signal / ON or OFF | ON: Slide door open to fully closed
OFF: Slide door fully closed |
- |
| Closer Position Switch | Slide door lock initial position switch signal / ON or OFF | ON: Slide door closer motor operating
OFF: Slide door closer motor stop (Initial position) |
- |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnosis Note |
|---|---|---|---|
| Pole Switch | Slide door lock pawl position switch signal / ON or OFF | ON: Slide door open to partially closed door or partially closed door to slide door closed
OFF: Slide door fully open, closed and partially closed |
- |
| Half Switch | Slide door lock half-latch switch signal / ON or OFF | ON: Slide door open to partially closed
OFF: Partially closed to fully closed |
- |
| Full Switch | Slide door lock full-latch switch signal / ON or OFF | ON: Slide door open to fully closed
OFF: Slide door fully closed |
- |
| Closer Position Switch | Slide door lock initial position switch signal / ON or OFF | ON: Slide door closer motor operating
OFF: Slide door closer motor stop (Initial position) |
- |