This DTC is output when a half-latch switch ON signal and full-latch switch OFF signal are input to the ECU simultaneously due to a switch signal malfunction.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2255 | Slide door closer switch LH malfunction | ·
Slide door lock LH ·
Wire harness ·
Power slide door ECU LH |
Use the Data List to check if the switch is functioning properly.
| Item | Measurement Item / Display (Range) | Normal Condition | Diagnosis Note |
|---|---|---|---|
| Half Switch | Slide door lock half-latch switch signal / ON or OFF | ON: Slide door open to partially closed
OFF: Partially closed to fully closed |
- |
| Full Switch | Slide door lock full-latch switch signal / ON or OFF | ON: Slide door open to fully closed
OFF: Slide door fully closed |
- |
When the switch is operating, the intelligent tester should display as shown in the table.
NG
OK
Remove the slide door lock LH.
Measure the resistance of the half and full latch position.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 - 7 | Open | Below 1 Ω |
| 6 - 7 | Half latch | 10 kΩ or higher |
| 6 - 7 | Full latch | 10 kΩ or higher |
| 6 - 7 | Over latch | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 5 - 7 | Open | Below 1 Ω |
| 5 - 7 | Half latch | 10 kΩ or higher |
| 5 - 7 | Full latch | 10 kΩ or higher |
| 5 - 7 | Over latch | Below 1 Ω |
OK
NG
Disconnect L5 slide door closer connector.
Disconnect L6 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| L5-6 (FUL) - L6-5 (FUL) | Below 1 Ω |
| L5-5 (HAF) - L6-12 (HAF) | Below 1 Ω |
| L5-7 (GND2) - Body ground | 10 kΩ or higher |
| L5-6 (FUL) - Body ground | 10 kΩ or higher |
| L5-5 (HAF) - Body ground | Below 1 Ω |
OK
NG