Home › Vehicle Interior › ENGINE HOOD / DOOR › HOOD › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292025 HOOD N

ENGINE HOOD / DOOR  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B057104E52
0.198,1.385 1.333,1.604 1.135,0.219 10 false Centering Bolt 2.208,1.438 3.271,1.667 1.063,0.229 10 false Standard Bolt

HINT:

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.


PROCEDURE

Hide 1.ADJUST HOOD SUB-ASSEMBLY

B136611

a.

Adjust the hood's position.

i.

Loosen the hood's 4 hinge bolts.


ii.

Move the hood and adjust the clearance between the hood and front fender. Make sure that the clearance is within the standard range.

B140504E05
2.688,0.531 2.906,0.729 0.219,0.198 10 false A 0.802,2.323 1.021,2.521 0.219,0.198 10 false C 2.74,1.063 2.958,1.26 0.219,0.198 10 false B

Standard measurement:
Area Specified Condition
A 3.5 mm (0.138 in.)
B 0 mm (0 in.)
C 4.0 mm (0.157 in.)



iii.

Tighten the hood's 4 hinge bolts after the adjustment.

Torque:
11.5 N*m (117 kgf*cm, 8 ft.*lbf)



b.
B136613

Adjust the cushion rubbers so that the height of the hood and fender are aligned.

i.
B136612E02
2.844,0.5 3.063,0.677 0.219,0.177 10 false A 2.604,2.365 3.094,2.594 0.49,0.229 10 true Aligned

Raise or lower the hood's front end by turning the cushion rubbers. Make sure that the clearance is within the standard range.

Standard measurement:
Area Specified Condition
A 3.5 mm (0.138 in.)




c.
B136911

Adjust the hood lock.

i.

Loosen the 3 bolts.


ii.
B136614

Adjust the hood lock position so that the striker can enter it smoothly.


iii.

Tighten the 3 bolts after the adjustment.

Torque:
7.5 N*m (77 kgf*cm, 66 in.*lbf)