Home › Vehicle Interior › ENGINE HOOD / DOOR › BACK DOOR
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292029 BACK DOOR N

ENGINE HOOD / DOOR  BACK DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
·
B057104E54
0.26,1.458 1.229,1.677 0.969,0.219 10 false Centering Bolt 2.167,1.479 3.146,1.729 0.979,0.25 10 false Standard Bolt

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.

·

Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.



PROCEDURE

Hide 67005 1.INSPECT BACK DOOR PANEL SUB-ASSEMBLY

a.

Check that the clearance is within the standard range.

B139526E02
1.708,2 1.865,2.177 0.156,0.177 10 false A 1.906,0.167 2.063,0.344 0.156,0.177 10 false B 5.656,1.083 5.813,1.26 0.156,0.177 10 false C 5.677,2.365 5.833,2.542 0.156,0.177 10 false D

Standard measurement:
Area Specified Condition
A 7.9 +-1.5 mm (0.252 +-0.37 in.)
B 7.2 +-1.5 mm (0.224 +-0.343 in.)
C 6.4 +-1.5 mm (0.193 +-0.311 in.)
D 4.1 +-1.5 mm (0.102 +-0.22 in.)



Hide 67005 2.ADJUST BACK DOOR PANEL SUB-ASSEMBLY

a.
B139527

Adjust the door forward/rearward and vertically by loosening the body side hinge.


b.

Tighten the body side hinge after the adjustment.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


c.

Using a screwdriver, remove the back door scuff plate.

HINT:

Tape the screwdriver tip before use.



d.
B139528

Adjust the striker position by slightly loosening the 2 striker mounting screws and hitting the striker with a plastic-faced hammer.


e.

Tighten the striker mounting screws after the adjustment.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)