Home › Vehicle Interior › ENGINE HOOD / DOOR › SLIDE DOOR
RM24M0E _58 Vehicle Interior _059569 ENGINE HOOD / DOOR _0292030 SLIDE DOOR N

ENGINE HOOD / DOOR  SLIDE DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

HINT:
·
B057104E53
0.25,1.375 1.385,1.594 1.135,0.219 10 false Centering Bolt 2.156,1.427 3.219,1.656 1.063,0.229 10 false Standard Bolt

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.

·

Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.



PROCEDURE

Hide 1.INSPECT SLIDE DOOR PANEL SUB-ASSEMBLY LH

a.

Check that the clearance is within the standard range.

B139511E01
0.842,1.557 0.997,1.738 0.156,0.181 10 A 1.017,0.459 1.173,0.640 0.156,0.181 10 B 6.515,0.206 6.671,0.387 0.156,0.181 10 C 6.043,1.494 6.198,1.675 0.156,0.181 10 D

Standard measurement:
Area Specified Condition
A 4.7 +-1.5 mm (0.126 +-0.244 in.)
B 6.9 +-1.5 mm (0.213 +-0.331 in.)
C 4.7 +-1.5 mm (0.126 +-0.244 in.)
D 15 +-2.0mm (0.512 +-0.669 in.)



Hide 2.ADJUST SLIDE DOOR PANEL SUB-ASSEMBLY LH

a.
B139512

Using SST, horizontally and vertically adjust the door by loosening the 3 hinge assembly center bolts.

SST
09812-00010  
09812-00020  


b.

Tighten the hinge assembly center bolts after the adjustment.

Torque:
19.5 N*m (199 kgf*cm, 14 ft.*lbf)


c.
B139513

Vertically adjust the front side of the door by loosening the 3 roller lower bolts.


d.

Tighten the roller lower bolts after the adjustment.

Torque:
19.5 N*m (199 kgf*cm, 14 ft.*lbf)


e.
B139514

Horizontally adjust the front lower side of the door by loosening the roller lower bolt.


f.

Tighten the roller lower bolt after the adjustment.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)


g.
B139515

Horizontally adjust the front upper side of the door by loosening the roller upper bolts.


h.

Tighten the roller upper bolts after the adjustment.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


i.
B058863

Adjust the position of the 2 door lock strikers by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.


j.

Tighten the 2 striker mounting screws after the adjustment.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)