Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059570 CRUISE CONTROL _0292039 CRUISE CONTROL SYSTEM J

CRUISE CONTROL  CRUISE CONTROL SYSTEM  Cruise Main Indicator Light Circuit  


DESCRIPTION

·

When the ECM detects a cruise control switch signal, it sends it to the combination meter through CAN communication. Then the CRUISE main indicator light comes on.

·

The CRUISE main indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Check the CRUISE main indicator light by performing the ACTIVE TEST.

Combination meter:
Item Test Details Diagnostic Note
Indicat. Lamp Cruise CRUISE indicator light
ON / OFF
-

OK:

Indicator light comes on / goes off.




OK

2.READ VALUE USING INTELLIGENT TESTER

NG

REPLACE COMBINATION METER

2.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the intelligent tester main switch on.


c.

Check the DATA LIST for proper functioning of the CRUISE main indicator light.

Cruise control (ECM)
Item Measurement Item / Display (Range) Normal Condition Diagnostic Note
CCS Indicator M-CPU Switch indicator (Main CPU) / ON or OFF ON: CRUISE main indicator light is ON
OFF: CRUISE main indicator light is OFF
-

OK:

When the cruise control main switch is operated, the display changes as shown above.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE ECM