INSPECT SET SWITCH
Push the main switch ON.
Drive at a desired speed (40 km/h (25 mph) or higher).
Press the control switch to the -/SET.
After releasing the switch, check that the vehicle cruises at the desired speed.
INSPECT "+" SWITCH
Push the main switch button to ON.
Drive at a desired speed (40 km/h (25 mph) or higher).
Press the control switch to the -/SET.
Check that the vehicle speed increases while the control switch is pulled up to +/RES, and that the vehicle cruises at the set speed when the switch is released.
Momentarily press the control switch upward to +/RES and then immediately release it. Check that the vehicle speed increases by about 1.6 km/h (1 mph) (Tap-up function).
INSPECT "-" SWITCH
Push the main switch button to ON.
Drive at a desired speed (40 km/h (25 mph) or higher).
Press the control switch to the -/SET.
Check that the vehicle speed decreases while the control switch is pushed down to -/SET, and the vehicle cruises at the set speed when the switch is released.
Momentarily press the control switch downward to -/SET, and then immediately release it. Check that the vehicle speed decreases by about 1.6 km/h (1 mph) (Tap-down function).
INSPECT CANCEL SWITCH
Push the main switch button to ON.
Drive at a desired speed (40 km/h (25 mph) or higher).
Press the control switch to the -/SET.
When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.
Depress the brake pedal
Push the cruise control main switch button to OFF
Push the cruise control switch to CANCEL
Shifting into any position other than D, during sequential shift mode; the shift lever is moved from S (4, 3) to "-" (2, 1). (U241E Automatic transaxle)
Shifting into any position other than D, during sequential shift mode from S (6, 5, 4) to "-" (3, 2, 1). (U660E Automatic transaxle)
Shifting into any position other than D, during sequential shift mode from M (7, 6, 5, 4) to "-" (3, 2, 1). (K112 Continuously variable transaxle)
INSPECT RES (RESUME) SWITCH
Push the main switch button to ON.
Drive at a desired speed (40 km/h (25 mph) or higher).
Press the control switch to the -/SET.
When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.
Depress the brake pedal
Push the cruise control main switch button to OFF
Push the cruise control switch to CANCEL
Shifting into any position other than D, during sequential shift mode; the shift lever is moved from S (4, 3) to "-" (2, 1). (U241E Automatic transaxle)
Shifting into any position other than D, during sequential shift mode from S (6, 5, 4) to "-" (3, 2, 1). (U660E Automatic transaxle)
Shifting into any position other than D, during sequential shift mode from M (7, 6, 5, 4) to "-" (3, 2, 1). (K112 Continuously variable transaxle)
RESUME function does not resume the set speed when the vehicle speed decreases below 40 km/h (25 mph).
After the control switch is pulled up to +/RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed before the cancellation.