Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM
RM24M0E _51 Engine / Hybrid System _059570 CRUISE CONTROL _0292039 CRUISE CONTROL SYSTEM U

CRUISE CONTROL  CRUISE CONTROL SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG).


c.

Read the Data List according to the display on the tester.

ECM
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
CCS Vehicle Spd Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph) Actual vehicle speed -
CCS Mem Vehicle Spd Vehicle speed / min.: 0 km/h (0 mph) max.: 200 km/h (125 mph) Actual vehicle speed stored in memory -
Cruise control Cruise control / ON or OFF ON: Cruise control is SET
OFF: Cruise control is UNSET
-
Main SW M-CPU Main switch (Main CPU) / ON or OFF ON: Main switch (Main CPU) is SET
OFF: Main switch (Main CPU) is UNSET
"1"
CCS Ready M-CPU Cruise control system standby condition (Main CPU) / ON or OFF ON: Main switch (Main CPU) is SET
OFF: Main switch (Main CPU) is UNSET
-
CCS Indicator M-CPU Switch indicator (Main CPU) / ON or OFF ON: CRUISE main indicator light is ON
OFF: CRUISE main indicator light is OFF
-
Cancel Switch CANCEL switch / ON or OFF ON: CANCEL switch is SET
OFF: CANCEL switch is UNSET
-
SET/COAST Switch -/SET switch / ON or OFF ON: -/SET switch is SET
OFF: -/SET switch is UNSET
-
RES/ACC Switch +/RES switch / ON or OFF ON: +/RES switch is SET
OFF: +/RES switch is UNSET
-
Stp Light SW M-CPU Stop light switch signal (Main CPU) / ON or OFF ON: Brake pedal depressed
OFF: Brake pedal released
-
Cruise Operation Status Shift D position / ON or OFF For U241E (Automatic transaxle):

ON: Shift is D or S (4th or 3rd) position

OFF: Shift is except D or S (4th or 3rd) position


For U660E (Automatic transaxle):

ON: Shift is D or S (6th, 5th, 4th) position

OFF: Shift is except D or S (6th, 5th, 4th) position


For K112 (Continuously variable transaxle):

ON: Shift is D or M (7th, 6th, 5th, 4th) position

OFF: Shift is except D or M (7th, 6th, 5th, 4th) position


-

HINT:

"1" is OK but CRUISE main indicator light does not illuminate → CRUISE main indicator light, wire harness, or ECM failure.