Home › Engine / Hybrid System › 2GR-FE STARTING › ENGINE SWITCH
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292071 ENGINE SWITCH G

2GR-FE STARTING  ENGINE SWITCH  INSPECTION  


PROCEDURE

Hide 89611 1.INSPECT ENGINE SWITCH

A129763E01
0.614,0.129 0.957,0.297 0.343,0.168 10 SS1 2.254,0.129 2.597,0.297 0.343,0.168 10 SS2 1.248,0.129 1.592,0.297 0.343,0.168 10 GND 0.783,0.912 0.783,0.342 false 2.426,0.912 2.426,0.342 false 1.438,0.912 1.438,0.342 false

a.

Measure the resistance of the switch.

Standard resistance:
Tester Connection Switch Position Specified Condition
7 (SS1) - 5 (GND) Not pushed 10 kΩ or higher
2 (SS2) - 5 (GND) Not pushed 10 kΩ or higher
7 (SS1) - 5 (GND) Pushed 15 Ω
2 (SS2) - 5 (GND) Pushed 15 Ω


If the result is not as specified, replace the engine switch.


b.

Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

HINT:
·

If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

·

If the voltage is too low, the indicator light will not illuminate.



OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 12 (INDS)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates
Battery positive (+) → Terminal 13 (INDW)
Battery negative (-) → Terminal 4 (COM) or 5 (GND)
Illuminates


A109252E07
5.916,1.513 6.390,1.714 0.474,0.201 10 SWIL 3.763,0.277 4.237,0.478 0.474,0.201 10 INDS 3.01,1.513 3.499,1.714 0.488,0.201 10 INDW 4.878,0.277 5.352,0.478 0.474,0.201 10 COM 4.359,0.277 4.834,0.478 0.474,0.201 10 GND 4.076,0.465 4.421,1.218 false 4.534,0.461 4.449,0.908 false 5.017,0.461 4.694,0.908 false 3.477,1.606 4.097,1.374 false 5.862,1.606 4.792,1.374 false 2.514,0.026 3.491,0.222 0.977,0.196 10 Indicator Light 1.619,0.403 2.298,0.098 2.298,0.098 2.438,0.098 false 2.363,0.35 3.475,0.957 1.111,0.607

If the result is not as specified, replace the engine switch.