This DTC is output when there is an open, short, or any other problem in the engine start request output circuit inside the main body ECU or in the external circuit.
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored. After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2275 | STSW output circuit (engine starting request signal circuit) inside main body ECU or other related circuit is malfunctioning | ·
Instrument panel junction block LH (Main body ECU) ·
ECM ·
Wire harness or connector |
Delete the DTCs (See page Engine / Hybrid System>2GR-FE STARTING>SMART ENTRY AND START SYSTEM>DTC CHECK / CLEAR).
After all DTCs are cleared, turn the engine switch on (IG) and depress the brake pedal. After 15 seconds have elapsed, check if the trouble occurs again.
Check for DTCs again.
No DTC is output.
OK
NG
Disconnect the G60 ECU connector.
Disconnect the A7 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G60-4 (STSW) - A7-14 (STSW) | Always | Below 1 Ω |
| G60-4 (STSW) - Body ground | Always | 10 kΩ or higher |
OK
NG
Reconnect the G60 connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G60-4 (STSW) - Body ground | Brake pedal depressed, Engine switch hold on (ST) | Output voltage at terminal AM1 or AM2 is -2 V or more. |
Terminal AM1: G57-6
Terminal AM2: G58-1
OK
NG
After replacing the main body ECU with a normally functioning ECU, check that the engine can start. Make sure the brake pedal is depressed and the shift position is P or N at this time.
Check that the engine switch mode can be changed by pushing the engine switch.
Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off. With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.
Engine starts normally.
If the engine does not start (See page Engine / Hybrid System>2GR-FE STARTING>SMART ENTRY AND START SYSTEM>Engine does not Start).
OK
NG