Home › Engine / Hybrid System › 2GR-FE STARTING › SMART ENTRY AND START SYSTEM
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292072 SMART ENTRY AND START SYSTEM C

2GR-FE STARTING  SMART ENTRY AND START SYSTEM  B2277  Detecting Vehicle Submersion  


DESCRIPTION

This DTC is output when the submersion circuit monitor inside the main body ECU detects that the vehicle is submerged in water.

HINT:

When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.

After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.


DTC No. DTC Detection Condition Trouble Area
B2277 Submersion circuit monitor inside main body ECU detects that vehicle is submerged in water Instrument panel junction block LH (Main body ECU)

PROCEDURE

1.CHECK FOR WATER DAMAGE
a.

Check the main body ECU, peripheral components, and wire harnesses for traces of water.

OK:

There are no traces of water.




OK

2.CHECK DTC OUTPUT

NG

TAKE APPROPRIATE MEASURES AGAINST CAUSE OF WATER DAMAGE AND REPLACE MAIN BODY ECU

2.CHECK DTC OUTPUT
a.

Delete the DTCs (See page Engine / Hybrid System>2GR-FE STARTING>SMART ENTRY AND START SYSTEM>DTC CHECK / CLEAR).

HINT:

After all DTCs are cleared, check if the trouble occurs again 30 seconds after the engine switch is turned on (IG).



b.

Check for DTCs again.

OK:

No DTC is output.




OK

END

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK LH (MAIN BODY ECU)