This DTC is output when a malfunction occurs in the IG1D output circuit, which is between the LH-IG relay 1 actuation circuit inside the main body ECU and the LH-IG relay 1.
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored. After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2272 | LH-IG relay 1 actuation circuit inside main body ECU or other related circuit is malfunctioning | ·
Instrument panel junction block LH (Main body ECU) ·
Instrument panel junction block RH ·
Wire harness or connector |
Disconnect the G57 main body ECU connector.
Disconnect the 5D instrument panel junction block RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified Condition |
|---|---|---|
| G57-3 (IG1D) - 5D-7 | Always | Below 1 Ω |
| G57-3 (IG1D) or 5D-7 - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the 5A instrument panel junction block RH connector.
Disconnect the 4A and 4D instrument panel junction block LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
|---|---|---|
| 5D-12 - 4D-11 | Always | Below 1 Ω |
| 5D-12 or 4D-11 - Body ground | Always | 10 kΩ or higher |
| 5A-4 - Body ground | Always | Below 1 Ω |
| 4A-5 - Body ground | Always | Below 1 Ω |
OK
NG
Measure the resistance according the value(s) in the table below.
| Tester connection | Condition | Specified condition |
|---|---|---|
| 5D-7 - 5D-12 | Always | Below 1 Ω |
| 5D-7 - 5A-4 | Always | Below 1 Ω |
| 5D-7 - Body ground | Always | 10 kΩ or higher |
OK
NG