This DTC is output when the submersion circuit monitor inside the main body ECU detects that the vehicle is submerged in water.
When the main body ECU is replaced with a new one and the negative (-) battery terminal is connected, the power source mode becomes the IG-ON mode. When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.
After the main body ECU is replaced, perform the registration procedures for the engine immobiliser system.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2277 | Submersion circuit monitor inside main body ECU detects that vehicle is submerged in water | Instrument panel junction block LH (Main body ECU) |
Check the main body ECU, peripheral components, and wire harnesses for traces of water.
There are no traces of water.
OK
NG
Delete the DTCs (See page Engine / Hybrid System>2GR-FE STARTING>PUSH-BUTTON START>DTC CHECK / CLEAR).
After all DTCs are cleared, check if the trouble occurs again 30 seconds after the engine switch is turned on (IG).
Check for DTCs again.
No DTC is output.
OK
NG