Home › Engine / Hybrid System › 2AZ-FE STARTING › STARTER(for 1.7 kW Type)
RM24M0E _51 Engine / Hybrid System _059575 2AZ-FE STARTING _0292079 STARTER(for 1.7 kW Type) A

2AZ-FE STARTING  STARTER(for 1.7 kW Type)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 2.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 53292A 3.REMOVE UPPER RADIATOR SUPPORT SEAL

Hide 74404B 4.REMOVE BATTERY CLAMP

a.
A133094

Remove the bolt and loosen the nut.


b.

Detach the 2 wire harness clamps.


c.

Detach the hook of the battery clamp from the front battery bracket, and then remove the battery clamp.


Hide 28899 5.REMOVE BATTERY INSULATOR

Hide 28800 6.REMOVE BATTERY

Hide 74431 7.REMOVE BATTERY TRAY

Hide 74411 8.REMOVE FRONT BATTERY BRACKET

a.
U188353

Detach the 2 wire harness clamps.


b.

Remove the 5 bolts and front bracket.


Hide 74414D 9.REMOVE BATTERY BRACKET REINFORCEMENT

A133096

a.

Remove the 2 bolts and bracket reinforcement.


Hide 28100 10.REMOVE STARTER ASSEMBLY

a.
A133097

Disconnect the starter connector.


b.

Open the terminal cap, remove the nut and disconnect the starter wire.


c.
A133101

Remove the 2 bolts and starter.