Home › Engine / Hybrid System › 2AZ-FE STARTING › SMART ENTRY AND START SYSTEM
RM24M0E _51 Engine / Hybrid System _059575 2AZ-FE STARTING _0292080 SMART ENTRY AND START SYSTEM C

2AZ-FE STARTING  SMART ENTRY AND START SYSTEM  B2281  "P" Signal Malfunction  


DESCRIPTION

This DTC B2281 is output when there is an abnormal circuit between the main body ECU and the shift lock control ECU.

DTC No. DTC Detection Condition Trouble Area
B2281 Communication or communication line is abnormal between main body ECU and shift lock control ECU
·

Main body ECU

·

Shift lock control ECU

·

Wire harness



WIRING DIAGRAM

A393977E02
1.24,1.958 1.823,2.208 0.583,0.25 10 false P2 1.646,1.844 2.229,2.094 0.583,0.25 10 false 11 5.5,1.823 6.083,2.073 0.583,0.25 10 false 2 5.729,1.958 6.313,2.208 0.583,0.25 10 false P 0.354,3.021 0.938,3.271 0.583,0.25 10 false G25 0.354,3.188 1.927,3.458 1.573,0.271 10 false Shift Lock Control ECU 5.698,3.031 6.281,3.281 0.583,0.25 10 false G60 5.708,3.198 6.771,3.458 1.063,0.26 10 false Main Body ECU

PROCEDURE

1.CHECK WIRE HARNESS (MAIN BODY ECU - SHIFT LOCK CONTROL ECU)
a.
U188394E02
1.948,1.813 2.375,2.01 false 1.969,4.198 2.563,4.406 false 0.094,0.083 1.708,0.24 1.615,0.156 10 false Wire Harness Side: 1.208,0.615 2.24,0.76 1.031,0.146 10 false Main Body ECU 0.688,1.958 0.969,2.104 0.281,0.146 10 false G60 2.448,1.979 2.573,2.135 0.125,0.156 10 false P 0.927,2.844 2.552,2.99 1.625,0.146 10 false Shift Lock Control ECU 0.552,3.854 0.833,4 0.281,0.146 10 false G25 2.625,4.354 2.844,4.51 0.219,0.156 10 false P2

Disconnect the G60 main body ECU connector.


b.

Disconnect the G25 shift lock control ECU connector.


c.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
G60-2 (P) - G25-11 (P2) Below 1 Ω
G60-2 (P) or G25-11 (P2) - Body ground 10 kΩ or higher




OK

2.CHECK SHIFT LOCK CONTROL ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK SHIFT LOCK CONTROL ECU
a.

Temporarily replace the shift lock control ECU with a new or normally functioning one.


b.

Check that the engine starts normally.

OK:

Engine starts normally.




OK

END (SHIFT LOCK CONTROL ECU IS FAULTY)

NG

REPLACE MAIN BODY ECU