The main body ECU and the combination meter are connected with a cable and the CAN communication line. DTC B2282 is output when signals, transmitted through the cable and the communication line, do not match.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2282 | Following conditions are met:
·
Signals between main body ECU and combination meter are inconsistent ·
Malfunction is detected in circuit between vehicle speed sensor and combination meter |
·
Main body ECU ·
Combination meter ·
Wire harness |
The skid control ECU converts these signals into 4-pulse signals and sends them to the combination meter. After these signals are converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, they are then transmitted to the main body ECU. The main body ECU determines the vehicle speed based on the frequencies of these pulse signals.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2283 | When both conditions below are met:
·
Vehicle speed decreases significantly ·
Vehicle speed does not correspond with engine speed |
·
Main body ECU ·
Combination meter ·
Speed sensor ·
Skid control ECU ·
Wire harness |
Connect the GTS to the DLC3.
Start the engine and turn the tester ON.
Select the following menu items: Body Electrical / Main Body ECU / Data List / Vehicle Spd Sig.
Read the display on the tester.
| Item | Measurement Item/Display (Range) | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Vehicle Speed Signal | Vehicle speed signal/ STOP or RUN | STOP: Vehicle is stopped
RUN: Vehicle is running |
- |
STOP appears on screen.
NG
OK
Disconnect the G59 main body ECU connector.
Disconnect the G28 combination meter connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G59-9 (SPD) - G28-40 (+S) | Below 1 Ω |
| G59-9 (SPD) or G28-40 (+S) - Body ground | 10 kΩ or higher |
OK
NG
Temporarily replace the main body ECU with a new or normally functioning one.
Check that the engine starts normally.
Engine starts normally.
OK
NG
(See pageVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)