Home › Engine / Hybrid System › 2AZ-FE STARTING › PUSH-BUTTON START › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059575 2AZ-FE STARTING _0292081 PUSH-BUTTON START C

2AZ-FE STARTING  PUSH-BUTTON START  B2276  ACCR Signal Circuit Malfunction  


DESCRIPTION

This DTC is output when a malfunction is detected in the ACCR signal output by the main body ECU.

DTC No. DTC Detection Condition Trouble Area
B2276 ACCR output circuit inside main body ECU or other related circuit is malfunctioning
·

Main body ECU

·

SFI system

·

Wire harness



WIRING DIAGRAM

A393977E04
1.073,1.958 1.656,2.208 0.583,0.25 10 false ACCR 1.646,1.844 2.229,2.094 0.583,0.25 10 false 13 5.5,1.823 6.083,2.073 0.583,0.25 10 false 3 5.729,1.958 6.313,2.208 0.583,0.25 10 false ACCR 0.667,3.021 1.25,3.271 0.583,0.25 10 false A7 0.667,3.188 1.25,3.438 0.583,0.25 10 false ECM 5.698,3.031 6.281,3.281 0.583,0.25 10 false G58 5.708,3.198 6.771,3.458 1.063,0.26 10 false Main Body ECU

PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG) and turn the tester ON.


c.

Clear the DTCs.


d.

Check whether DTC B2276 recurs 50 seconds or more after the engine switch is turned on (IG).

Result:
Display (DTC output) Proceed to
B2276 A
No DTC output B




A

2.CHECK MAIN BODY ECU (ACCR VOLTAGE)

B

END (SYSTEM IS OK)

2.CHECK MAIN BODY ECU (ACCR VOLTAGE)
a.

Disconnect the G58 main body ECU connector.


b.

Measure the voltage of the wire harness side connector when operating the engine switch to crank the engine.

Standard voltage:
Tester Connection Specified Condition
G58-3 (ACCR) - Body ground 10 to 14 V




OK

3.CHECK WIRE HARNESS (MAIN BODY ECU - ECM)

NG

4.CHECK MAIN BODY ECU
3.CHECK WIRE HARNESS (MAIN BODY ECU - ECM)
a.

Disconnect the G58 main body ECU connector.


b.

Disconnect the A7 ECM connector.


c.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
G58-3 (ACCR) - A7-13 (ACCR) Below 1 Ω
G58-3 (ACCR) or A7-13 (ACCR) - Body ground 10 kΩ or higher




OK

4.CHECK MAIN BODY ECU

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK MAIN BODY ECU
a.

Temporarily replace the main body ECU with a new or normally functioning one.


b.

Check whether DTC B2276 recurs by repeating the "CHECK WHETHER DTC OUTPUT RECURS" procedures above.

OK:

No DTC is output.




OK

END (MAIN BODY ECU IS FAULTY)

NG