This DTC is output when a malfunction is detected in the ACCR signal output by the main body ECU.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2276 | ACCR output circuit inside main body ECU or other related circuit is malfunctioning | ·
Main body ECU ·
SFI system ·
Wire harness |
Connect the GTS to the DLC3.
Turn the engine switch on (IG) and turn the tester ON.
Clear the DTCs.
Check whether DTC B2276 recurs 50 seconds or more after the engine switch is turned on (IG).
| Display (DTC output) | Proceed to |
|---|---|
| B2276 | A |
| No DTC output | B |
A
B
Disconnect the G58 main body ECU connector.
Measure the voltage of the wire harness side connector when operating the engine switch to crank the engine.
| Tester Connection | Specified Condition |
|---|---|
| G58-3 (ACCR) - Body ground | 10 to 14 V |
OK
NG
Disconnect the G58 main body ECU connector.
Disconnect the A7 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G58-3 (ACCR) - A7-13 (ACCR) | Below 1 Ω |
| G58-3 (ACCR) or A7-13 (ACCR) - Body ground | 10 kΩ or higher |
OK
NG
Temporarily replace the main body ECU with a new or normally functioning one.
Check whether DTC B2276 recurs by repeating the "CHECK WHETHER DTC OUTPUT RECURS" procedures above.
No DTC is output.
OK
NG
(See pageEngine / Hybrid System>2AZ-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)