Home › Engine / Hybrid System › 2AZ-FE CHARGING › GENERATOR
RM24M0E _51 Engine / Hybrid System _059576 2AZ-FE CHARGING _0292084 GENERATOR G

2AZ-FE CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

A079305E17
0.563,0.125 0.344,0.125 0.344,0.125 0.552,0.958 false 0.625,0.042 1.115,0.24 0.49,0.198 10 false Length

a.

Using a vernier caliper, measure the brush length.

Standard length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum length:

4.5 mm (0.177 in.)


If the brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

A097476E21
1.938,0.417 1.656,0.927 false 1.938,0.417 1.802,0.969 false 1.74,0.146 2.333,0.323 0.594,0.177 10 false Slip Ring

a.

Check the resistance.

i.

Measure the resistance between the slip rings.

Standard resistance:

1.5 to 1.9 Ω at 20°C (68°F)


If the result is not as specified, replace the generator rotor assembly.


ii.
A097477E20
1.792,0.979 2.021,0.104 2.021,0.104 2.104,0.104 false 0.885,0.958 1.052,1.625 false 0.719,1.646 1.438,1.813 0.719,0.167 10 false Rotor Core 2.167,0.021 2.792,0.198 0.625,0.177 10 false Slip Ring

Measure the resistance between the slip ring and rotor core.

Standard resistance:

1 MΩ or higher


If the result is not as specified, replace the generator rotor assembly.



b.
A097470

Check the slip ring diameter.

i.

Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.4 mm (0.559 to 0.567 in.)


Minimum diameter:

14 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.



c.
A097469

Check the appearance.

i.

Check that the bearing is not rough or worn.

OK:

The bearing rotates smoothly.


If the result is not as specified, replace the generator rotor assembly.



Hide 27310B 3.INSPECT GENERATOR DRIVE END FRAME BEARING

A097471

a.

Check that the bearing is not rough or worn.

OK:

The bearing rotates smoothly.


If the bearing does not rotate smoothly, replace the bearing.


Hide 27415 4.INSPECT GENERATOR PULLEY WITH CLUTCH

a.
A126783E01
0.641,0.714 0.959,0.881 0.317,0.167 10 Free 2.515,0.712 2.832,0.879 0.317,0.167 10 Lock

Hold the center of the pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

If the result is not as specified, replace the generator pulley with clutch.