Home › Engine / Hybrid System › 2AZ-FE CHARGING › GENERATOR
RM24M0E _51 Engine / Hybrid System _059576 2AZ-FE CHARGING _0292084 GENERATOR A

2AZ-FE CHARGING  GENERATOR  DISASSEMBLY  


PROCEDURE

Hide 27415 1.REMOVE GENERATOR PULLEY WITH CLUTCH

a.
A126771

Remove the cap from the pulley.

i.

Using a screwdriver, puncture the center of the cap and pry it off.

NOTICE:

Do not reuse the cap.




b.
A126778E01
2.381,1.342 2.937,1.531 0.556,0.189 10 SST (A) 0.297,1.45 0.838,1.628 0.541,0.178 10 SST (B) 1.406,1.828 1.21,1.551 false 1.212,1.556 0.945,1.556 false 1.745,1.426 2.36,1.426 false

Install SST (A and B) to the pulley as shown in the illustration.

SST
09820-63020  


c.

Mount SST (A) in a vise.


d.
A126779E02
2.177,1.531 2.708,1.531 false 2.74,1.438 3.333,1.719 0.594,0.281 10 true SST (B)

Turn SST (B) clockwise to loosen the pulley.


e.

Remove the pulley.


Hide 27370 2.REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

A130331

a.

Remove the 3 nuts and generator rear end cover.


b.
A097461

Remove the terminal insulator.


c.
A097462

Remove the 2 screws and generator brush holder.


Hide 27330 3.REMOVE GENERATOR ROTOR ASSEMBLY

a.
A097464

Remove the bolt and cord clip.


b.
A097465

Remove the 4 bolts.


c.
A131653E01
0.374,0.276 0.697,0.494 0.323,0.219 10 SST 1.813,0.972 1.294,0.357 false 1.294,0.357 0.738,0.357 false

Using SST, remove the coil.

SST
09950-40011  (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010)


d.

Remove the washer.


e.

Remove the generator rotor.