Home › Engine / Hybrid System › 2AZ-FE CHARGING › GENERATOR
RM24M0E _51 Engine / Hybrid System _059576 2AZ-FE CHARGING _0292084 GENERATOR A

2AZ-FE CHARGING  GENERATOR  REASSEMBLY  


PROCEDURE

Hide 27330 1.INSTALL GENERATOR ROTOR ASSEMBLY

a.
A097468

Install the washer onto the generator rectifier end frame.


b.
A097467

Install the generator rotor onto the generator rectifier end frame.


c.
A097475E04
0.906,0.188 1.667,0.448 false 0.365,0.073 0.854,0.656 0.49,0.583 10 false 32 mm Socket Wrench

Using a 32 mm socket wrench and press, slowly push the generator drive end frame onto the generator rectifier end frame.


d.
A097465

Tighten the 4 bolts.

Torque:
5.8 N*m (59 kgf*cm, 51 in.*lbf)


e.
A097464

Install the cord clip with the bolt.

Torque:
4.6 N*m (47 kgf*cm, 41 in.*lbf)


Hide 27370 2.INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

a.
A079315E47
0.938,0.75 1.104,0.333 1.104,0.333 2.51,0.896 false 0.99,0.135 1.354,0.302 0.365,0.167 10 false Pin

While pushing the 2 brushes into the generator brush holder, insert a φ1.0 mm (0.039 in.) pin into the generator brush holder.


b.
A097463E05
2.219,0.156 1.813,0.563 false 1.094,0.073 1.635,0.313 0.542,0.24 10 true Pull out 2.292,0.042 3.24,0.406 0.948,0.365 10 false Pin

Install the generator brush holder with the 2 screws.

Torque:
1.8 N*m (18 kgf*cm, 16 in.*lbf)


c.

Pull the pin out of the generator brush holder.


d.
A097461

Install the terminal insulator onto the generator rectifier end frame.


e.
A098216

Install the generator rear end cover with the 3 nuts.

Torque:
4.6 N*m (47 kgf*cm, 41 in.*lbf)


Hide 27415 3.INSTALL GENERATOR PULLEY WITH CLUTCH

a.

Install the pulley by hand.


b.
A126778E01
2.381,1.342 2.937,1.531 0.556,0.189 10 SST (A) 0.297,1.45 0.838,1.628 0.541,0.178 10 SST (B) 1.406,1.828 1.21,1.551 false 1.212,1.556 0.945,1.556 false 1.745,1.426 2.36,1.426 false

Install SST (A and B) to the pulley and vise as shown in the illustration.

SST
09820-63020  


c.
A126782E02
2.146,1.552 2.583,1.552 false 2.625,1.469 3.146,1.76 0.521,0.292 10 true SST (B)

Turn SST (B) counterclockwise to tighten the pulley.

Torque:
111 N*m (1132 kgf*cm, 82 ft.*lbf)


d.

Install a new cap to the pulley.


e.

Check that the generator pulley rotates smoothly.