Home › Engine / Hybrid System › 2GR-FE CHARGING › CHARGING SYSTEM
RM24M0E _51 Engine / Hybrid System _059577 2GR-FE CHARGING _0292085 CHARGING SYSTEM J

2GR-FE CHARGING  CHARGING SYSTEM  Noise Occurs from Generator while Engine is Running  


PROCEDURE

1.CHECK LOOSENESS OF V-RIBBED BELT
a.

Check the tension of the belt by pushing it down with a finger.

OK:

The tension of the belt is enough.




OK

2.CHECK V-RIBBED BELT FOR WEAR

NG

REPLACE V-RIBBED BELT TENSIONER ASSEMBLY

2.CHECK V-RIBBED BELT FOR WEAR
a.

Check the V-ribbed belt for wear.

OK:

The V-ribbed belt is not worn.




OK

3.CHECK CLUTCH PULLEY FOR WEAR

NG

REPLACE V-RIBBED BELT

3.CHECK CLUTCH PULLEY FOR WEAR
a.

Check the clutch pulley groove for wear or other defects.

OK:

The clutch pulley groove is not damaged.




OK

4.CHECK FOR NOISE WHILE CLUTCH PULLEY IS OPERATING

NG

REPLACE CLUTCH PULLEY

4.CHECK FOR NOISE WHILE CLUTCH PULLEY IS OPERATING
a.

Perform a road test and check if noise occurs when decelerating.

OK:

Noise does not occur.




OK

REPLACE GENERATOR ASSEMBLY

NG

REPLACE CLUTCH PULLEY