Home › Engine / Hybrid System › 2GR-FE CHARGING › GENERATOR
RM24M0E _51 Engine / Hybrid System _059577 2GR-FE CHARGING _0292086 GENERATOR A

2GR-FE CHARGING  GENERATOR  REPLACEMENT  


PROCEDURE

Hide 27310B 1.REPLACE GENERATOR DRIVE END FRAME BEARING

a.
A128076

Remove the 4 screws and retainer plate from the drive end frame.


b.
A128077E01
0.187,0.662 0.485,0.807 0.298,0.145 10 SST 1.308,0.98 0.573,0.778 0.573,0.778 1.249,1.236 false

Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.

SST
09950-60010  (09951-00250)
09950-70010  (09951-07100)


c.
A128081E01
0.363,0.43 0.661,0.575 0.298,0.145 10 SST 1.389,0.7 0.711,0.559 0.711,0.559 1.23,1.129 false

Using SST and a press, press in a new generator drive end frame bearing.

SST
09950-60010  (09951-00470)
09950-70010  (09951-07100)


d.
A137712E12
2.583,1.052 1.948,0.896 false 2.531,1.531 1.938,1.823 false 1.688,0.792 1.948,0.938 0.26,0.146 10 false Tab 1.438,1.75 1.885,1.896 0.448,0.146 10 false Cutout

Fit the tabs on the retainer plate into the cutouts on the drive end frame to install the retainer plate.


e.

Install the 4 screws.

Torque:
2.3 N*m (23 kgf*cm, 20 in.*lbf)